Actiontec GT-701wg Bridged Configuration

These configuration instructions will guide you through configuring your Actiontec modem in Transparent Bridging mode. You must set up the Actiontec modem before configuring your computer with any information sent by our DSL department.

1. Follow the instructions provided with your Actiontec modem to connect your Actiontec modem to your computer and DSL line.
   
   Your computer should be configured to obtain an IP address automatically from the Actiontec modem. If you are using a Macintosh, select to Configure Using: DHCP Server.
2. Open a web browser and enter 192.168.0.1 in the Address Bar. You should see the following screen:


If you do not see this screen, first check your cables to make sure you have a solid Ethernet light on the Actiontec modem, then reboot your computer and try accessing the Actiontec modem again.

3. Click on Setup / Configuration
4. Now you should see the Setup / Configuration screen.

5. We're going to skip the Basic Setup, so just click on Advanced Setup on the left.
6. There really isn't anything to do on this page except to click on Begin Advanced Setup

7. On this screen, click on Next.

8. On the Wan IP Address screen, select Transparent Bridging.

9. Now, click on Save and Restart in the lower left corner of the screen.
10. Click on the big Save and Restart button.

11. Once the Power light on the modem stops blinking, you're done. You will still need to configure any devices or computers behind the modem with the static IP information provided by SpiritOne.